LS-C

Accessory

Mini Quantum Sensor

Design of sensor

Small versatile waterproof mini quantum sensor for selective PAR measurement, cosine corrected for light incident at an angle between -30 ° to +30 ° from surface normal for PPFD (photosynthetical photon flux density) measurement, with base plate for screw connection.

Sensor housing

Black resin material

Diffuser material

Perspex

Signal detection

High stability silicone photovoltaic detector with filter set for PAR correction (see “General Features” for typical response)

Signal output
Typically 10 μA / (1000 μmol m-2 s-1)
Temperature coefficient of photodiode

0.01 %/K

Absolute calibration
± 10 %
Immersion coefficient
Typically 1.15
Angular dependence
Error < 3 % for angle between -30 ° and +30 ° from normal axis (see chart for typical response)
Design of sensor
Microscopy quantum sensor for PPFD (photosynthetical photon flux density) measurement.
Operating temperature
- 5 °C … + 45 °C
Cable length
3 m
Connector

BNC

Size

Base plate: 12 mm x 7 mm x 1 mm (H x W x L)
Sensor housing 5 mm x 7.5 mm x 7 mm (H x W x L)
Diffuser diameter: 3 mm

Weight

26 g

Design of sensor

Microscopy quantum sensor for PPFD (photosynthetical photon flux density) measurement.

Sensor housing

Black anodized aluminum housing

Diffuser material

Resin with fluorescence dye

Signal detection

High stability silicon photovoltaic. Signal output typically 1.5 μA / (1000 μmol m-2 s-1)

Temperature coefficient of photodiode

0.01 %/K

Absolute calibration

± 5 %

Operating temperature

0 °C … + 40 °C

Cable length

55 cm

Connector

BNC

Power supply

Not required

Size

Height: 5.5 mm
Length: 76 mm
Width: 26 mm
Diffuser diameter: 0.2 mm

Weight
36 g